Quadro SW-Version 4.1.x Installationsanleitung PDF herunterladen (Seite 102)

Quadro Manual II: Administrator's Guide Appendix: System Default Values

QuadroISDN; SW Version 4.1.x 102

Parameter System Default Value

Redirection on Timeout – disabled,

Enable welcome message – enabled,

Welcome message, Recurring Attendant Prompt and Attendant Ringing

Announcement – default,

Authorized Phones Database – undefined.

Attendant 00 Settings – SIP

Registration username and password - automatically generated,

SIP server - sip.epygi.com,

SIP Server port – 5060,

SIP Server Registration – disabled.

Attendant 00 Settings – SIP

Advanced

Authentication User Name – undefined,

Send Keep-alive Messages to Proxy – disabled,

RTP Priority Level – medium,

Outbound Proxy, Secondary SIP Server and Outbound Proxy for Secondary SIP

Server – undefined.

Attendant 00 Settings - Codecs

Codecs - G711u (preferred), G711a, G726/16, G726/24, G726/32, G726/40, G729a,

G723, iLBC

Codec state – all Codecs in the list enabled,

Out of Band DTMF Transport – enabled,

T.38 FAX – enabled,

Pass Through FAX – enabled,

Pass Through Modem – disabled,

Force Self Codecs Preference for Inbound Calls - disabled.

Universal Extension Recordings Default, Percentage of System Memory – 3%.

Call Statistics

Enabled

100 entries for all type of calls

SIP Settings

UDP and TCP Port – 5060,

Session Timer – disabled,

DNS Server for SIP – default,

SIP timers – RFC 3261.

RTP Settings

Properties for all Codecs except G723 and iLBC :

Packetization -20ms

Silence Suppression -yes

G723 and iLBC properties:

Packetization - 30ms

Silence Suppression – yes

RTP/RTCP port range for FXS lines - 6000-6099

G276 Standard - ITU-T specification

Telephone Event Draft Support - enabled

RTCP Support - disabled

NAT Traversal Settings

NAT Traversal for SIP – Automatic

SIP and RTP Parameters - Use STUN

SIP TCP Port – 5060

STUN Parameters:

Primary STUN Server - stun.epygi.com

Primary STUN Port – 3478

Secondary STUN Server – undefined

Secondary STUN Port - undefined

Polling Interval: 1 hour

Keep-alive interval: 120 seconds

NAT IP checking interval: 300 seconds

No entries in NAT Exclusion table

ISDN Settings

ISDN Trunks - Trunk 1, Trunk 2, Trunk 3 and Trunk 4 exist.

Settings for all Trunks:

State – started,

Interface – User,

Coding Type - a-law,

Loopback mode - no loopback,

Passive Mode – disabled,

Signaling settings for all Trunks:

DID Service – disabled,

TEI Mode – Automat, TEI Assignment on Power up – enabled,

MSN Settings - No other devices connected to ISDN bus,

Route Incoming Call to - 00,

Use Default outgoing MSN – enabled,

1 2 ... 97 98 99 100 101 102 103 104 105 106

Kommentare zu diesen Handbüchern

Keine Kommentare

Quadro SW-Version 4.1.x Installationsanleitung Seite 102

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für PBX-Systeme (Premise Branch Exchange) Quadro SW-Version 4.1.x